If you replace a filament bulb with an LED bulb without a built-in resistor (marked "not CAN bus compatible" on our products), an error message is likely to appear on the dashboard or, worse, the bulb may light up and then go out instantly.
This problem can be solved by fitting these external resistors. They are simple to install, in parallel with the bulb. Simply clamp the positive + wire and the negative - wire with the connectors supplied, without cutting the original cable.
These 3 watt resistors are for replacing 4 to 6 watt bulbs with an LED bulb (front or rear sidelights, number plate lights).