If you replace a filament bulb with an LED bulb without a built-in resistor (marked "not CAN bus compatible" on our products), an error message is likely to appear on the dashboard or, worse, the bulb may light up and then go out instantly.
This problem can be solved by fitting these external resistors. They are simple to install, in parallel with the bulb.
This version has a 3W channel (white wire, 0.25A@12V) and a 15W channel (red wire, 1.27A@12V). It is suitable for dual-filament bulbs (P21/5W, W21/5W, P27/7W, etc.) or for 2 separate bulbs (for example a W5W and a P21W).